DIY: Burlap Earring Organizer for Post Earrings

I’ve shared a few of my jewelry organizers with you on the blog. Such as my Frame turned Earring Holder and more recently my Corkboard Necklace Holder. I discovered that I needed to make an addition to my jewelry organizers for my post earrings. I got out the corkboard and burlap and came up with this DIY Earring Organizer!

Supplies you’ll need:

• Corkboard (you don’t need a lot, I used a 5X5 square)
• Burlap
• Jute Twine
• Hot Glue Gun
• Scissors
• Crop-A-Dile (If you don’t have it, get it, you’ll love it. Find it on Amazon.com)

 

How To:

Take the corkboard and measure out the length of burlap you will need. This should be about 1 inch longer than each side.

Cut the burlap and place the corkboard on top in the middle creating an even look.

Take the hot glue gun and start gluing each side down one time at a time. When onto the last one, be sure to pull taught.

Once the glue is dried, take the Crop-A-Dile and punch holes in the top so that the jute/twine can hold the earring holder.

Thread the Jute through and tie knots on the back ends.

 

Linked up at: http://www.the36thavenue.com/